Spin Blade 0.5mm-0.9mm

A thin chisel with a blade width of less than 1mm that can be attached to a pin vise!
Great for engraving details on figures and mini-mechas!
Ultra-fine size with a blade width of less than 1 mm that can easily process flat bottoms of round holes!
Excellent usability as a thin carving knife.

It is attached to the pin vise body and used as a small carving knife to flatten the bottom of drill holes.
The size is 0.5mm ~ 0.9mm (5 piece set).
Since the axis is unified to 3 mm, replacement of the collet chuck of the pin vise body is not required, making it easy to replace.
Excellent compatibility with drill bit 5-piece set A.

*Because it is a knife, please handle with care when opening the lid or using it.

How to use
・Attach the drill blade to the pin vise and dig a hole
・Attach a spin blade with the same diameter as the drilled hole to the pin vise.
・Scrub the bottom of the carved hole with a spin blade.

It can flatten the bottom (drill edge processing) of a hole drilled with a drill edge of the same diameter.
A chisel with a thin blade of 0.5 mm, 0.6 mm, 0.7 mm, 0.8 mm, and 0.9 mm with a unified blade size for a 3 mm shaft size.

⚠NOTE
・Please fix the pin vise firmly in place before use.
・Please be sure no one is around and wear protective glasses.
　Cutting materials or broken blades in the eyes may cause blindness.
・Blades made of hard metal, however, may damage or injure unexpectedly if excessive force is applied or improperly used.
・After use, wipe with a dry cloth, lubricate with oil, and place in the case.
・Please be careful to avoid injury
・Please do not apply a load exceeding the capacity.
・When spinning the Spin Blade, ensure to drill pilot holes with the same diameter before use.